对于软件可选择的CAN卡,将硬件配置成单线模式
硬件: Industrial Communications>>CAN>>PCI-CAN/SW, Industrial Communications>>CAN>>PCI-CAN/SW Series 2, Industrial Communications>>CAN>>PXI-8464/1 Series 2, Industrial Communications>>CAN>>PXI-8464/2 Series 2
问题: 我想设置软件可选择的NI-CAN PXI卡的硬件为单线传输,我该如何做?
解答: 当您设置您的PXI-8464为单线模式,需要遵循以下几个步骤。
1. 断电,从机箱中取出PXI-8464,改变您将使用的”Ext“的端口的电池电压跳线。再将卡插入机箱,然后上电。
2. 在MAX下右击CAN端口选择属性,端口的属性窗口将出现,设置传输类型为单线。
3. 按照如下的方式连线:
管脚3(V-):连线到您供电电源(e.g 0V)的负端或者公共端。
管脚5(保护):连线到地(未必与管脚3一样)。如果您的供电电源是接地的,那就是一样的。
管脚6(V-参考):连线同管脚3一样。
管脚7(CAN_H):连线到您的模块的CAN线。
管脚9 (V+):连线到您的供电电源的正极(e.g +12V)。
您现在就可以以单线模式使用您的软件可选择的NI-CAN卡。
相关链接: Product Reference: NI-CAN Hardware and Software Manual
附件:
报告日期: 04/19/2007
最近更新: 06/21/2011
文档编号: 48II5OYW
Other Support Options
Ask the NI Community
Collaborate with other users in our discussion forums
Request Support from an Engineer
A valid service agreement may be required, and support options vary by country.