LED Signaling
- Updated2023-05-01
- 1 minute(s) read
LED Signaling
The GPIB-USB-HS controller uses two LEDs to indicate status and activity.
When you connect the GPIB-USB-HS controller, the READY LED lights either green or amber once the driver is installed and detected. The following table summarizes the functionality of the LEDs on the GPIB-USB-HS hardware.
LED | Description |
---|---|
READY | Green indicates that the GPIB-USB-HS is plugged into a USB full-speed (USB 1.1) port. Amber indicates that the GPIB-USB-HS is plugged into a USB Hi-Speed (USB 2.0) port. |
ACTIVE | Indicates activity on the GPIB bus. |
The GPIB-USB-HS+ controller uses a multicolored LED to indicate status and activity. The following table summarizes the functionality of the LEDs on the GPIB-USB-HS+ hardware.
LED | Description |
---|---|
Alternating Amber/Green | The GPIB-USB-HS+ is not ready to use. You must install (or re-install) the NI-488.2 driver before using the GPIB-USB-HS+. Note: Windows 8 and later suspend power to a USB device that does not have a driver attached. If the LED does not light, try reinstalling the NI-488.2 driver. |
Steady Green | Indicates that the GPIB-USB-HS+ is plugged into a USB full-speed (USB 1.1) port. |
Steady Amber | Indicates that the GPIB-USB-HS+ is plugged into a USB Hi-Speed (USB 2.0) port. |
Blinking Amber or Green | Indicates activity on the GPIB bus or that the GPIB Analyzer is capturing. |