Seeing Error 0x3FF6200C (1073094668) In My CAN ApplicationHardware: Industrial Communications>>CAN
Problem: I am getting error NI-CAN: (Hex 0x3FF6200C) CAN transceiver warning, typically indicated by the NERR signal. A fault exists on the bus, but communication continues. Solution: Verify that cabling is correct. in my LabVIEW program. I don't seem to be seeing all my frames on the CAN bus and ncAction doesn't always work. Why am I seeing strange behavior? Solution: The reason why you would be seeing this error code is due to lack of proper termination of your CAN bus. Terminating resistors are required to ensure proper communication on the CAN bus.The KnowledgeBase articles linked below contain more information about termination requirements for both High and Low-Speed CAN. Related Links: KnowledgeBase 37UJ2DV4: NI-CAN: High Speed Interface Does Not Work at High Speeds KnowledgeBase 3IABNOHS: Proper Termination for NI-CAN Hardware KnowledgeBase 29K9J4P7: Symptoms of Improper CAN Termination KnowledgeBase 37GGN4W3: Do the NI-CAN Devices Support Split Termination? Attachments:
Report Date: 10/14/2004 Last Updated: 03/27/2009 Document ID: 3EDASE7T |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
