Using SC-206X Boards with M Series DAQ Devices Hardware: Multifunction DAQ (MIO)>>M Series, Signal Conditioning Other>>SC Digital Accessories>>SC-2062, Signal Conditioning Other>>SC Digital Accessories>>SC-2060, Signal Conditioning Other>>SC Digital Accessories>>SC-2061
Problem: Can I use the SC-206X boards with M Series DAQ boards? Solution: Yes, the SC-206X boards can be used with M Series DAQ devices. The following is required to connect the DAQ device to the SC-206X boards:
The "Connecting 206X with M Series" file below shows a block diagram of the connection. The SC-206X series consists of 3 digital signal conditioning devices: SC-2060, SC-2061, and SC-2062. SC-2060 optically isolates digital input. The SC-2061 and SC-2062 boards isolate digital output signals optically and using electromechanical relays respectively. Because the output lines of SC-2061 are open-collector lines, it’s necessary to use pull-up resistors to obtain valid output. NI recommends using a pull-up resistor of 4.7kOhms. The "SC-2061 Output Connection" diagram below illustrates this. Related Links: Product Manual: SC-206X User Manual KB 3ECDRBPK:Can I Use M Series Boards With ER-8/16 Relay Module? KB 3FDC9SNK: Using SSR Modules with M Series DAQ Devices KB 3FDCUMNK: Using SC-204X Boards with M Series DAQ Devices KB143F47QH: Connecting the Correct SC-207X Breadboard to an SCXI-1180 Feedthrough Panel KB 3FDDDJNK: Using BNC-208X Boards with M Series DAQ Devices Attachments:  
Report Date: 11/14/2004 Last Updated: 04/20/2007 Document ID: 3FDD52NK |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
