This Document is not yet Rated

Rate this Document

Error Message "Calibration Sequence Error" when running the Calibration Procedure.

Primary Software: Calibration Executive
Primary Software Version: 1.0
Primary Software Fixed Version: N/A
Secondary Software: N/A

Problem:
When I run the Calibration Executive procedure, the first two steps including the self-calibration are properly passed, but the third step is failing. I obtain the following message "Calibration Sequence Error", and the execution stops and a blank report is generated (see below). It occurs in automatic and manual mode.

How do I fix this problem?

Solution:
This error occurs if your computer is set to use a comma instead of a period for decimal points.

1. Go to Start » Settings » Control Panel.
2. Click on Regional Settings.
3. Click the Numbers tab
4. Change the Decimal Symbol from a comma (,) to a period (.). In additon, you should change the Digit Grouping Symbol from (.) to (,).

Related Links:
KnowledgeBase 229ENA8A: Error -15 from E Series Procedure of Calibration Executive

Attachments:





Report Date: 04/29/2004
Last Updated: 04/14/2008
Document ID: 38S9FUI9

Your Feedback!	Poor  |  Excellent							Yes	No
Document Quality?							Answered Your Question?
	1	2	3	4	5
Document needs work? Please tell us why.
Please Contact NI for all product and support inquiries.