This Document is not yet Rated

Rate this Document

GPIB-ENET Installation and Configuration under Windows NT

Hardware: GPIB>>External Controllers/Convertors>>GPIB-ENET

Problem:
How do I install and configure my GPIB-ENET in Windows NT?

Solution:

1. Be sure that you installed the GPIB-ENET on the network on the same subnet (hub) as your computer and connected the power cable.
   
   
2. If your GPIB-ENET has not yet been assigned an IP address, then you must assign an IP address to it.
   
   
3. Go to Start » Settings » Control Panel and open the GPIB Configuration Utility, which will launch the GPIB Configuration window:
   
   

   

   
   
4. Click the Board Type button and select GPIB-ENET, as shown below:
   
   

   

   
   Click OK.
   
   
5. Click the Configure button in the GPIB Configuration window. This will open a GPIB# (GPIB-ENET) window, like this one:
   
   

   

   
   
6. Enter the IP address of the GPIB-ENET in the Host Name field and click OK. This will configure your computer to communicate with the GPIB-ENET.
   
   
7. Click OK in the GPIB Configuration window.
   
   
8. You are now ready to connect instruments to the GPIB-ENET and communicate with them. See the Introduction to the Interactive Control (IBIC) page for more information.

Related Links:

Attachments:


- enetcfg1.JPG
- enetcfg2.JPG
- enetcfg3.JPG



Report Date: 09/14/2006
Last Updated: 09/29/2006
Document ID: 41DCQKDW

Your Feedback!	Poor  |  Excellent							Yes	No
Document Quality?							Answered Your Question?
	1	2	3	4	5
Document needs work? Please tell us why.
Please Contact NI for all product and support inquiries.