Configuring Sweep Step in SignalExpress 1.1.1 Runs My User-Defined Step Primary Software: LabVIEW Signal Express>>Development SystemPrimary Software Version: 1.1.1 Primary Software Fixed Version: 1.2 Secondary Software: N/A
Problem: Configuring a Sweep step in SignalExpress 1.1.1 by adding or changing parameters causes my User-Defined Step to run even after unchecking Run This Step Automatically. Why is this happening? Solution: After configuring or reconfiguring a Sweep step, SignalExpress will run through the Sweep operation. This may cause undesired behavior if you are using a User-Defined Step which requires an instrument and the instrument is not currently connected to your computer or is not active. Unchecking the Run This Step Automatically should prevent the User-Defined Step from executing in this manner, but it does not when the User-Defined Step is contained within a Sweep operation. SignalExpress Patch_1.1.1.002 fixes this behavior. Please visit the SignalExpress 1.1.1 Drivers and Updates page linked below to download and read more about this patch. Related Links: Drivers and Updates: SignalExpress Version 1.1.1 for Windows 2000/NT/XP -- Updates KnowledgeBase 3WPK09RX: SignalExpress User-Defined Steps with LabVIEW 8.x VIs KnowledgeBase 3XELPCQP: Saving to ASCII Files Using SignalExpress 1.1.1 KnowledgeBase 41RGBFTT: Data Logged To File using SignalExpress Is Corrupted Attachments:
Report Date: 09/28/2006 Last Updated: 03/19/2007 Document ID: 41RFRGTT |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
