This manual contains instructions to help you install and configure the National Instruments AT-GPIB/TNT interface board and the NI-488.2 multitasking software (NI-488.2M) driver for the HP-UX operating system, version 9.01 and higher. The hardware and software are intended for use on an HP 9000 Series 700 workstation. This manual is meant to be used with the NI-488.2M Software Reference Manual. This manual uses the term AT-GPIB/TNT to refer to a National Instruments GPIB board equipped with the TNT4882C ASIC. The term AT-GPIB refers to a National Instruments GPIB board equipped with the NAT4882 and Turbo488 ASICs. This manual uses the term GPIB board in cases where the material can apply to either board. Both boards are designed for use with the ISA (PC AT) bus, but they can be used in EISA systems, such as the HP 9000 Series 700. This manual assumes that you are already familiar with the HP 9000 Series 700 workstation and the HP-UX operating system.

	View the document in Adobe Acrobat PDF format. (File size: 261 KB)

Right-click the link above and select Save Link/Target As to download the document to your computer.

Your Feedback!	Poor  |  Excellent							Yes	No
Document Quality?							Answered Your Question?
Add Comments		1	2	3	4	5