Getting Started with Your AT-GPIB/TNT and the NI-488.2 Software for DOS
| Edition Date: |
June 1997 |
| Part Number: |
320718C-01 |
|
This manual contains instructions to help you install and configure the National
Instruments AT-GPIB/TNT or AT-GPIB interface board and the NI-488.2 software for
DOS. The NI-488.2 software is intended for use with MS-DOS version 3.0 or higher (or
equivalent).
This manual uses the term AT-GPIB/TNT to refer to a National Instruments GPIB board
for the ISA (PC AT) bus equipped with the TNT4882C ASIC. The term AT-GPIB refers
to a National Instruments GPIB board for the ISA (PC AT) bus equipped with the
NAT4882 and Turbo488 ASICs. This manual also uses the term GPIB board in cases
where the material can apply to either board.
This manual assumes that you are already familiar with DOS.
 |
View the document in Adobe Acrobat PDF format. (File size: 131 KB) |
Right-click the link above and select Save Link/Target As to download the document to your computer.
